Honda outboard service/repair manual – Seloc | 4-stroke | 4 stroke | Table of Contents PDF file | 2 hp – hp – 4 hp – 8 hp – 40 hp – 50 hp – 75 . Clymer Honda Outboard Marine service and repair manuals are written with model specific coverage for your Honda Outboard Marine. From basic service and. View and Download Honda Outboard Motor BFA owner’s manual online. Honda Power Equipment Outboard Motor Owner’s Manual. Outboard Motor.
|Published (Last):||3 June 2017|
|PDF File Size:||15.59 Mb|
|ePub File Size:||13.78 Mb|
|Price:||Free* [*Free Regsitration Required]|
Don’t have an account?
Engine Oil Recommendations Clean the oil filter honra base, and coat the rubber seal of the new oil filter with clean engine oil.
Correction Insert clip in stop switch. Loosen the vapor separator drain screw. When the boat is to be moored for a long time, tilt the outboard motor as far as it will go.
Honda outboard repair manual – Table of Contents PDF file
Bad fuel; boat stored without treating or draining gasoline, or refueled with bad fuel. Insert the mud guard clips with the inner part raised off, then push in the inner part securely until they click. Attach the emergency stop switch lanyard securely to your PFD or to your wrist.
Remove the fuse case lid. Cleaner Air and Water – for healthier lifestyle and environment. Remove and inspect spark plugs. Old gasoline will cause hard starting, and it leaves gum deposits that clog the fuel system. If there was water in the engine crankcase, or if the used engine oil showed signs of water contamination, then a second engine oil change should be performed after running the engine for half an hour.
Always stop the engine if you must leave the controls for any reason. Page 75 Remove the three screws and separate the fuel strainer cup from the strainer body. Misfiring or backfiring under load. It is necessary for the ignition switch to be in the ON position for the trim meter to indicate the motor angle.
HONDA OUTBOARD MOTOR BFA OWNER’S MANUAL Pdf Download.
Stop the engine and keep heat, sparks, and flame away. Transporting Use a motor support bar to prevent the outboard motor from moving while trailering the boat. Normal Engine Stopping To stop the engine in an emergency, pull the clip out of the emergency stop switch by pulling the lanyard.
Use the minimum throttle opening necessary to operate the boat at a safe trolling speed. Running the engine with persistent spark knock or pinging can cause engine damage. Stop the engine immediately if anyone falls overboard, and do not run the engine while the boat is near anyone in the water. Check that the fuel hose is undamaged and properly connected. Fast Idle Button The switch clip must be inserted in the emergency stop switch in order for the engine to start and run.
Honda Four-Stroke Outboard marine manuals
For manual tilting, use a screwdriver to turn the valve counterclockwise 1 or 2 turns. If there is still no water flowing from the cooling system indicator, or if the engine protection system remains activated after 30 seconds, return to the nearest boat landing, and have the outboard motor inspected by an authorized Honda marine dealer.
Remove the old fuse by removing two 5 mm screws. mankal
Digital Tachometer optional equipment Digital Tachometer includes the following functions. Top-mount Type The emergency stop switch clip and lanyard system is a safety device that will stop the engine if you fall away from the controls while operating the boat.
Honda Outboard Motor BF135A Owner’s Manual
Keep these items on the boat, so they will always be available if you need them. Refuel carefully to avoid spilling fuel.
We suggest that you stop the engine this way occasionally to verify that the emergency stop switch is operating properly. The Symbol for Cleaner Marine Engines: If a label comes off or becomes hard to read, contact an authorized Honda Marine servicing dealer for a replacement. The 10A main fuse protects the ignition switch and related circuits.
Honda power equipment outboard motor owner’s manual 45 pages.
Never refill the fuel tank inside a building where gasoline fumes may reach flames or sparks. This outboard motor uses spark plugs that have an iridium coated center electrode. Possible Cause Fast idle lever raised side-mount type.
Enter text from picture: Thoroughly clean the strainer cup, and replace with a new fuel filter.
The engine will not start if the F forward or R reverse gears are engaged. Failure to properly follow maintenance instructions and precautions can cause We are certain you will be pleased with your purchase of one of the finest outboard motors on the market.